5 Troubleshooting Tips to Fix Netgear Ex

0
0
0 visits

5 Troubleshooting Tips to Fix Netgear Extender Red Light Issue

Are you fed up with seeing your Netgear extender constantly blinking red? Have you tried every hack but nothing worked in your favor? If the answer to these questions is a big yes, then fret not! You're in safe hands. We've mentioned some tips in this article that'll help you get rid of the Netgear extender red light issue in a flash! So, read on.

Resolved: Netgear Extender Red Light Issue

  • Check the Connection Between Your Devices

If the connection between your Netgear range extender and WiFi router is poor, then it's quite obvious why you're stuck with the red light issue. Thus, make sure you establish a strong connection between your WiFi devices. It is recommended that you use an Ethernet cable to create a connection between your devices. Doing so will ensure your devices don't lose connection.

  • Change the Location of Your Extender

Before performing Netgear extender setup, did you choose the right location to place your device? Probably not! Otherwise, you wouldn't be facing the extender red light issue. But, the good news is that you have a chance to rectify your mistake. So, waste no more time in relocating your Netgear range extender.

Place your Netgear extender in a well-ventilated area, away from corners. Also, do not place your extender near devices like cordless phones, baby monitors, washing machines, refrigerators, microwave ovens, Bluetooth speakers, etc. The reason being, such devices can mess with the WiFi signals of your extender, thereby making it vulnerable to technical issues.

  • Perform Netgear Firmware Update

Updating the firmware of your Netgear WiFi extender is another thing that you can do to get rid of the red light issue. In order to update your device, you need to access mywifiext. If you want to learn how to perform Netgear extender firmware update at a deeper level, follow the steps mentioned below:

  • Connect your extender to the WiFi router using a wire.

  • Launch an internet browser on your computer.

  • Type www.mywifiext.net in the address bar of your internet browser, and hit Enter.

  • Fill in the default Netgear extender login credentials, and click on the Log In button.

  • Once logged in, go to Settings and click on the Administration option.

  • Now, click on the Firmware Update or Extender Update option.

Once you are done updating the firmware of your extender, check if the red light issue has been fixed or not. If not, then keep reading.

  • Call Your Internet Service Provider

Chances are that your internet connection is weak due to which you are facing the Netgear extender red light issue. Therefore, call your Internet Service Provider and check if the issue is from his side. If it is, ask him to get it fixed as soon as possible.

  • Reset Your WiFi Extender

Have none of the troubleshooting steps worked for you so far? Can you still see your Netgear extender blinking red? If yes, then it looks like you have no other option than to reset your WiFi device.

Walk through the steps mentioned below to restore your extender to the factory default mode:

  • Check whether your extender is receiving a fluctuation-free power supply.

  • Then, look for the Reset button located on your WiFi extender.

  • Once found, carefully press the button using a pin-like object.

  • Now, give your extender a minute to get restored to its factory default settings.

Once you have performed factory default reset, don't forget to perform mywifiext.net setup.

Conclusion

This was all about the troubleshooting steps to get rid of the Netgear extender red light issue. We hope that this article was of some help to you in fixing the red light issue. In case it was, then feel free to drop a word of appreciation in the comment section below.


11 Sep, 2021
Ratings
(0 votes)
Your rating
Collected
michaelwatkins
michaelwatkins